＿
13
＿
Starting and Stopping
Before Starting the Engine
1. Fill the fuel tank as instructed in the Before Operation section of this manual.
2. Rest the Trimmer/ Brushcutter on the ground.
3. Make sure the cutting attachment is clear of any broken glass, nails, wire, rocks or other debris.
4. Keep all bystanders, children and animals away from the working area.
Cold Starting Procedure
The carburetor on this engine is equipped with a fuel primer and a choke system.
To start a “cold” engine properly, perform the following procedure:
1. Pump the primer bulb until fuel can be seen owing through the fuel return line to the fuel tank. Flowing
fuel should be almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the Close
“ ” position.
3. With the stop switch “START” (ON), and the throttle trigger positioned at Fast-idle start position, pull the
starter grip. After the engine is started, turn the choke lever to the Open
“ ” position. Then squeeze and
release the throttle trigger to allow it to return to the idle position.
[BC2301RS, BC2601RS, BC3021RS]
[BC4321H-RS]
Choke
Lever
Open
Primer Bulb
Fuel Return Line
Starter Grip
Close
Choke Lever
Open
Close
Primer Bulb
Fuel Return Line
Choke Lever
Starter Grip
To Next Page
Loading...
