4
112
Dashboard Instruments and Controls
Passive Speed Limit Set
This indicator indicates the
passive speed limit set via the
controls on the RH side of the
steering wheel (for further details,
refer to "TFT Display Setting and Menu
Overview" in this section).
Passive Speed Limit Exceeded
This warning light informs the
driver that the speed limit that
was set has been exceeded.
Suspension Setting Indicator Light
This indicator light displays
which suspensions setting (soft
"S" or hard "H") is on. For
further details, refer to “Drive Mode”
in section “Starting and Driving”.
Drive Mode Indicator Light
Drive mode set by the driver
through the controls on central
console is displayed above the
transmission lever indicator (example
in picture: NORMAL). For further
details, refer to “Drive Mode” in
section "Starting and Driving".
Cruise Control (CC) Ready or Canceled
This white indicator light will
illuminate when the CC is
ready to be set (with 3 dashes
below) and, once it sets, when it is
temporarily canceled (set speed in
white below). For further information,
check "Cruise Control - CC” in section
"Driver Assistance Systems".
Cruise Control (CC) Set
This green indicator light will
illuminate with the set speed
when the CC is set and in driver
override. For further information,
check "Cruise Control - CC" in section
"Driver Assistance Systems".
Blind Spot Assist (BSA) or Active Blind
Spot Assist /ABSA) Ready and Active
This white indicator light
indicates that the BSA is in
stand-by (ready): the same
indicator light in green color
indicates that the system is
active.
Active Blind Spot Assist (ABSA)
Intervention
This amber indicator light
indicates the intervention of
the system on the steering to
avoid a potentially dangerous lane
change.
For further information, see "Active
Blind Spot Assistance - ABSA" in
section "Driving Assistance systems".
Speed Limiter (SL) Indicator Light
This white or green indicator
light will illuminate when the
SL function is on, or set and in
driver override (with green set
speed below) or temporarily
canceled (with white set speed
below). For further information, check
“Speed Limiter - SL” in section “Driver
Assistance Systems".
Lane Keeping Assist (LKA) Fault
This warning light on indicates
that the LKA system is in fault.
If the warning light and the
relevant message do not go off after
a few manoeuvres and eventually
an ignition cycle, contact the Service
Network.
Active Driving Assist (ADA) Fail
This warning light will turn on
to indicate a failure of the ADA
system.
Contact the Service Network as soon
as possible avoiding using this system.
Adaptive Cruise Control (ACC) Ready
or Canceled
This white indicator light
indicates that the ACC is ready
to be set (with 3 dashes below)
and, once it sets, when it is temporarily
canceled (set speed in white below).
For further details, refer to "Adaptive
To Next Page
Loading...
