Maserati Ghibli - Interior Lighting

2
39
Understanding the Vehicle
When instead there is the needing
to switch off the whole high beam
module to obtain the no glaring
effect, on the instrument cluster there
will be just one indicator on: the green
one.
When the scenario allows the partial
or full use of high beam with no
glaring disturbance, the blue indicator
will appear again.
NOTE:
• Some unpredictable conditions,
such as dirt, dust, film or any
other obstruction on camera lens
zone events could affect "Glare
Free" function making it working
improperly.
• Heavy rainy and foggy weather could
affect system performance, leaving
the full beam switched on for longer
time than the nominal working
condition. This could cause a glaring
disturbance for other vehicles, to
avoid this the driver has to switch off
the high beam manually.
• In phase of disengagement of the
function, the minimum operating
speed is 25 km/h (15.5 mph).
• "Glare Free" function proper
operation is guaranteed if vehicle
speed is less than, or at least equal to
250 km/h (155 mph).
Automatic High Beam/Glare Free High
Beams Failure
In the event of a failure on high beam
system (Automatic or Glare Free
equipped, as well), the related amber
warning light will light up on the TFT
display.
Take your vehicle to the nearest
Center of the Service Network as soon
as possible avoiding to use this system.
Interior Lighting
The interior and external approach
lights turn on and off when
entering/exiting the vehicle (see
"Illuminated Entry/Exit" in section
"Before Starting" for further
information).
The brightness of the ambient lights,
controls and instruments can be
manually adjusted with the regulator
positioned beside the light switch
as described in the chapter "Light
Controls" in section "Dashboard
Instruments and Controls".
For backlight operation, see paragraph
"Ambient Lights and Backlight
Adjustment" of chapter "Illuminated
Entry/Exit" in section "Before Starting"
Dome Lights
The front and rear part of the dome,
include each a central and two reading
lights.
The central light automatically turns
on when one of the doors is opened
and turns off when the door is closed
(timed switching off). The light may be
switched on manually by pressing the
central button.
The reading lights are controlled by
the respective side buttons.