2
33
Understanding the Vehicle
in section "Dashboard Instruments
and Controls").
• If the mirrors are automatically
folded after the last lock action, then
they will automatically unfold when
the ignition device is set on ACC or
RUN position.
• If the mirrors were manually folded
by the switch on the driver's door
panel, before a lock action, they will
need to be manually unfolded to
reactivate the automatic function.
CAUTION!
Never retract or open the mirrors
manually: it could damage the power
mechanism.
Internal Rear-view Mirror
The position of internal rear-view
mirror can be manually adjusted,
and is endowed with an accident-
prevention release system operating in
the event of a collision.
Internal rear-view mirror is
electrochromic: this glare function is
automatically deactivated in reverse to
ensure maximum visibility of obstacles.
CAUTION!
To avoid damage to the mirror during
cleaning, never spray any cleaning
solution directly onto the mirror. Apply
the solution onto a clean cloth and
wipe the mirror clean.
"Mirror Dimmer" Function
The auto-dimming function can be
disabled or re-enabled by pressing the
on/off button on the mirror base.
Typical case is at night when the
auto-dimming can be excessive (low
reflectance). Disabling this function
will increase the reflectance of the
internal mirror, increasing visibility.
External Lighting
External Lights Equipment
The vehicle is equipped with lighting
systems and functions that depend on
the type of equipment and the target
market. Some of these are completely
automatic, other can be switched on
and off via the light switch and the
multifunction lever on the dashboard,
or via "Controls" and "Settings" menu
of "Vehicle" page on MIA.
This chapter only describes systems
that may or may not be installed
because of the various options
available.
For switching the external lights
on and off via the light switch and
the multifunction lever behind the
steering wheel, refer to the chapter
"Light Controls" in section "Dashboard
Instruments and Controls".
External Lights Cluster
The lights of the front clusters are
arranged as follows:
Bi-Xenon Version
1 Low-beam/high-beam light: Bi-
Xenon bulb 25W.
2 Position and DRL light LED.
3 Turn signal LED.
4 Side-marker light LED.
5 Side reflex-reflector.
To Next Page
Loading...
