4
134
Dashboard Instruments and Controls
The following table shows the on/off condition of external lights, according to the ignition device position, to the engine
status, to the twilight sensor mode and to the light switch position.
Ignition
Device
Position
Engine
Status
Twilight
Sensor
Mode
Light Switch Position
AUTO
OFF – –
Position lights (1), side
marker and license plate
lights on (4).
All lights off. Low beams, position (1),
side marker and license
plate lights on.
ACC Off –
Position lights (1), side
marker and license plate
lights on (2).
All lights off. Low beams, position (1),
side marker and license
plate lights on (2).
RUN Off –
Position lights (1), side
marker and license plate
lights on (2).
All lights off. Low beams, position (1),
side marker and license
plate lights on (2).
RUN On DAY
DRL (1) on. DRL (1) on. Low beams, position (1),
side marker and license
plate lights on.
RUN On NIGHT
Low beams, position (1),
side marker and license
plate lights on (3).
Low beams, position (1),
side marker and license
plate lights on.
Low beams, position (1),
side marker and license
plate lights on.
(1) The lighting system uses the same LED for DRL and front position lights with two different levels of intensity: high
for DRL and low for position lights.
(2) The lights are powered up for 30 minutes to preserve the charge of the battery.
(3) In some countries a message on TFT display alerts the user to use position when parking because the position
lights will turn on with engine started also in low ambient light conditions or at night.
(4) To preserve the charge of the battery, do not leave these lights on for a long time.
To Next Page
Loading...
