6
238
Driver Assistance Systems
Other Cases
The BSA system is not designed to
issue an alert on stationary objects
such as guardrails, posts, walls,
foliage heaps, berms, etc. However,
occasionally the system may alert on
such objects. This is normal operation
and your vehicle does not require
service.
The BSA system will not alert you
of objects that are travelling in the
opposite direction of the vehicle in
adjacent lanes.
WARNING!
•
The Blind Spot Assist (BSA) system is
only an aid to help detect vehicles in
the blind spot zones.
•
The BSA system is not designed
to detect pedestrians, cyclists, or
animals.
•
Even if your vehicle is equipped
with the BSA system, always check
your vehicle’s outside and rear-view
mirrors for any vehicles approaching
from behind or overtaking.
•
Use your turn signal before changing
lanes.
System Monitoring on TFT
Display
Whenever the BSA system is enabled
by the user, an specific indicator is
displayed in the left upper corner of
the TFT display (area 22). This indicator
can take on different colors depending
on the system status:
stand by status (white icon);
active status (green icon).
RCP - Rear Cross Path ( )
The Rear Cross Path (RCP) feature is
intended to aid the drivers when gear
in reverse of parking spaces where
their vision of oncoming vehicles may
be blocked.
The RCP system monitors the rear
detection zones on both sides of the
vehicle. Using sensors located on either
side of the rear bumper, it detects
vehicles or objects that are moving
toward the side of the vehicle with a
minimum speed of approximately
1 km/h to 3 km/h (1 to 2 mph) to
a maximum of approximately 16
km/h (10 mph), such as in parking lot
situations.
NOTE:
In a parking lot situation, oncoming
vehicles can be obscured by vehicles
parked on either side. If the sensors
are blocked by other structures or
To Next Page
Loading...
