2
83
Understanding the Vehicle
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to ON position
without starting the engine.
• Place the garage door opener
transmitter 1 to 3 inches (3 - 8 cm)
away from the Homelink
®
button you
wish to program.
• Push and hold the Homelink
®
button
you want to program while you push
and hold the garage door opener
transmitter button you are trying to
replicate.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
NOTE:
The distance necessary between the
portable hand-held transmitter and the
HomeLink
®
in the vehicle depends on the
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
Synchronizing the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
®
has been
programmed for a rolling code system,
it will be necessary to synchronize it to
ensure its correct operation.
• Locate the “LEARN” or “TRAINING”
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when
the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the next
step after the setting button has been
pressed.
• Return to the vehicle and press the
programmed HomeLink
®
button for two
seconds and then release it.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
HomeLink
®
buttons, repeat the same
step for the same remaining button. DO
NOT erase the channels.
Reprogramming a Single HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to ON position
without starting the engine.
• Press and hold the desired HomeLink
®
button.
• Without releasing the button proceed
with “Programming the hand-held
transmitters” from second step and
follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before 1995
• Turn the ignition device to ON position
without starting the engine.
• Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the
HomeLink
®
button you wish to program.
• Simultaneously press and hold both
buttons until the warning light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
To Next Page
Loading...
