MINIMUM INSTALLATION CLEARANCES
(To heat sensitive surfaces)
❇
FLUED APPLIANCES
NO FLOOR PROTECTOR (HEARTH) IS REQUIRED
Alcove installation not permitted.
INSTALLATION
SHIMS
The glass panels are protected from shipping damage by paper shims fitted between the
front and side glasses. Before lighting the heater, remove the shims.
GAS
Access to the gas connection point is obtained by removing the cover panel on the rear of
the cabinet. (Four screws)
Connection is made to the Boston LP model using a 3/8” BSP fitting. The other models
use a 1/2” BSP fitting.
3