21
Seat
Seat Removal
Pull up on the front of the seat and slide it toward the front of the vehicle.
Install the seat by sliding the tabs into the rear of the seat base. Push down firmly on the front of the
seat until the pins are fully seated into the grommets.
Seat Belts
This vehicle is equipped with three-point lap seat belts for
the operator and passenger. Always make sure the seat belts
are secured for both the operator and passenger before riding.
To wear the seat belt properly, follow this procedure:
1. Take up the seat belts which are located on the edges of
seat and across your shoulders just like wear a coat. The
buckle is in front of your abdomen. Make sure the belt is
not twisted.
Tip: The position of the shoulder strap can be adjusted
to the height of the operator.
2. Push the latch plate into the buckle until it clicks.
3. Press the red release latch on the buckle to release
the seat belt.
To Next Page
Loading...
