51
Cooling system
1. Place the vehicle on a level surface.
2. Check the coolant level in the coolant reservoir when the engine is cold as the coolant level will
vary with engine temperature.
3. If the coolant is at or below the minimum level mark, open the front cargo box ,you will see the
coolant cap , remove the cap, add coolant to the maximum level mark, install the reservoir cap.
Don’t removing the radiator cap when the engine and radiator are still hot, or you could be burned
by hot fluid nd steam blown out under pressure. Wait for the engine to cool before removing the
radiator cap. Always use a thick rag over the cap. Allow any remaining pressure to escape before
completely removing the cap.
NOTE: The coolant should be between the minimum and maximum level marks.
To Next Page
Loading...
