01 02
Please carefully read the instruction manual before
using the tester, and pay special attention to “Warning”
content. Please follow instructions under “Warning”.
1. Please be very careful when test voltage is higher
than AC 30 V, and do keep in mind that your finger
shall not exceed the hand-shielding part of the
test probe.
2. Do not measure voltage which is higher than the
allowed input limit.
3. Before use, please check the meter and test probe;
do not carry out testing in case the test probe is
naked, tester housing is damaged, or there is no
LCD display, etc..
4. It meets requirements of safety standards only when
the meter is used together with the supplied test
probes. In case the test probe is damaged and
needs replacement, it is required to replace it with
a test probe of the same model and identical
electrical specifications.
5. Please never carry out any voltage measurement
whenever the test probe is inserted in any current
outlet.
Safety Instructions
Important safety signs; please refer to
instruction manual
High voltage hazard
Earthing
Double insulation (Category-II safety
equipment)
Battery low Indicator
The three-phase clamp-type digital power meter is
designed and manufactured in accordance with
international standard, IEC61010-1, and international
safety specification, IEC1010-2-032, and the meter
strictly follows the safety standard of double-insulation
AC 600 V CAT III.
6. Please do not expose the meter to strong light, high
temperature, or dampness.
Warning
Before use, please carefully read this instruction
manual.Especially safety contents!
Safety Sign
General Description
The 3-phase clamp-type digital power meter is a hand-
held intelligent harmonic power tester, with both functions
of digital current testing and power testing. The tester is
comprised of three channels including voltage, current,
and power as well as a micro single chip system, and it is
equipped with a powerful software for measurement and
data processing functions; it can measure, calculate,
and display voltage, current, active power, power factor,
apparent power, passive power, frequency, harmonic
parameters, with stable performance and operation
convenience. The meter is especially suitable for the
measurement and examination of on-site power
equipment and power-supplying circuits; with hand-held
Safety Requirements
To Next Page
Loading...
Need help?
General
