03 04
clamp structure, small volume, and light weight, it can
be easily carried by the user, which makes it easy and
fast for doing measurement. For measurement of sing-
phase/three-phase power, The meter is your ideal
choice
Features
1.The meter can be used for testing power, voltage,
current, peak value, phase, frequency, power factor,
phase angle, and reaction factor, etc. of single-/
three-phase circuit; automatic phase sequence
testing is possible for 3-phase measurement.
2. True effective value measurement: accurate
measurement is possible even with serious
distortion in current waveform.
3. Low-consumption high-speed single-chip
microprocessor is employed and sophisticated
algorithm is applied, as a result, results can be
obtained rapidly and precisely, and up to 20
harmonics and distortion value thereof can be
measured.
4. It is equipped with a large-size memory for saving
up to 100 groups of test parameters.
5. It is equipped with RS232C communication and
recording interface and dedicated WINDOWS
graphics software.
6. Hand-held, clamp-type structure, with light weight,
convenient for carry-on.
Appearance
kW
1 PHASE
Ø
1 PHASE
kW/ Ø
3 PHASE
HARM
A~
V~
HARM
°
APS
RS232
HOLD
REC
FS
LAG
LEA D
RST
CAL
USED
READ
MEMO
COS Φ
SIN Φ
MAX MIN
VA
kWh
PEA K
%THD
kVA
Hz
HzA
PEAK
kWVAh
POWER CLAMP METER
MS2205
Yrue RM S
Harmo nic
AUTO RA NGE
MODE I
U READ
CLEARRS232
Watt
SET
COM/V2
EN61010-1
600V CAT III
V3V1
HOLD
OFF
MAX~
600V
MAX
600V~
1
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
