17 18
NOTE:
• Unstable display may occur especially at 400mV range,
even though you do not put test leads into input
terminals, in this case, if an erroneous reading is
suspected, short the V terminal and the COM terminal,
and make sure the zero display.
• For better accuracy when measuring the dc offset of an
ac voltage, measure the ac voltage first. Note the ac
voltage range, then manually select a dc voltage range
equal to or higher than the ac range. This improves the
accuracy of the dc measurement by ensuring that the
input protection circuits are not activated.
AC Voltage
DC Voltage
DIG ITAL MU LTI MET ER DIG ITAL MU LTI MET ER
To Next Page
Loading...
Need help?
General
