9
IGNITION VIA MATCH
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
If you encounter a problem with the ignition mechanism, or if you
have dead batteries, it is possible to light the heater with a match.
(Fig. 14)
The procedure is as follows:
• Turn the wick adjuster knob clockwise until the wick has been
raised to its maximum height.
• Lift the burn chamber by using the burner knob. Touch a lighted
match to the exposed top edge of the wick.
• Once you see that the wick has been lit, lower the burn chamber
back down over the wick.
• Rotate the burner knob from side to side a few times to make
sure that the burner is positioned properly on the wick adjuster.
• Then begin following the steps outlined in “Adjusting the wick” (page 11).
CAUTION: Make sure that you do not leave the match, or any portion of it (match head, etc.) in the
burner area. Debris left from the match can cause an uneven alignment of the burner and may result
in smoke, incomplete combustion, odor, or re.
.
WICK
1~2mm
IGNITER
FILAMENT
Fig.14
Match
To Next Page
Loading...