EasyManua.ls Logo

Masterbuilt 20070311 - User Manual

Masterbuilt 20070311
2 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SMOKER SIDE SHELF
Upright Position
With both hands on the left and right of the shelf, lift
smoker side shelf. When shelf is in full upright position,
push the shelf gently towards the smoker. The hinge will
then drop and lock into place.
Downward Position
Again, with both hands on each side of the smoker side
shelf, slightly lift the shelf to remove it from its locked
position, then gently pull towards yourself and swing the
shelf into its downward position.
FITS MASTERBUILT 30-in. MODELS: 20070411, 20070911, 20071011, 20071111
FITS MASTERBUILT 40-in. MODELS: 20070211, 20070212, 20070311, 20071211,
20071311, 20071411, 20071611, 20071711
POSITIONING
Model# 20101513
Masterbuilt Manufacturing, Inc. · 1 Masterbuilt Ct. Columbus, GA 31907 · Customer Service / Servicio de atención al cliente: 1-800-489-1581 · www.masterbuilt.com
081612-04SS
MADE IN CHINA
C
A
1
Facing right side of smoker, remove door hinge
cover screw (A) and door hinge cover (B), then re-
move only the closest door hinge screws (C) from
hinge. (Do not remove far rear screws as the door
will loosen and the seal could be compromised.)
1
Still facing the right side of smoker, slightly loosen
handle screws (D) and completely remove handle
screws (D) closest to you, allowing rear handle (E)
to move freely.
2
Insert hinge cover screw (A) through door hinge
cover (B), then take nut (F) and thread onto screw
taking care not to fully tighten screw; leaving a
slight gap between the nut (F), door hinge cover
(B) and screw (A).
3
With smoker side shelf (G) in downward position,
align shelf support bracket and holes onto the right
side of smoker body as shown.
With side shelf (G) between smoker body and
handle (E), replace handle screws (D) and door
hinge screws (C). Tighten all screws at this time.
Re-set door hinge cover (B) over door hinge and
secure with door hinge cover screw (A) as shown.
Shelf installation is now complete.
4
2 3
4
E
E
G
C
B
B
CAUTION
· SMOKER SIDE SHELF WEIGHT CAPACITY 25 LBS.
· NEVER MOVE SMOKER WITH SHELF IN UPRIGHT POSITION.
· DO NOT SIT ON OR LEAN AGAINST SHELF.
· WHEN ADJUSTING SHELF, KEEP FINGERS CLEAR OF HINGES.
D
D
A
D
B
A
F

Other manuals for Masterbuilt 20070311

Preview: Assembly, Care & Use Manual
Assembly, Care & Use Manual30 pages
Preview: Care & Use Manual
Care & Use Manual20 pages

Questions and Answers

  • M
    Matthew ClarkJul 31, 2025
    How to clean a Masterbuilt Grill smoker?
    • D
      Daniel MillerJul 31, 2025
      To clean your Masterbuilt Grill smoker, follow these steps: * For smoking racks, water bowl, and drip tray, use a mild dish detergent. Rinse and dry thoroughly. * Clean the wood chip tray and wood chip loader frequently to remove ash build-up, residue, and dust. * Wipe down the interior, glass in the door, light cover, meat probe, and exterior with a damp cloth. Do not use cleaning agents and dry thoroughly. * Clean the door seal and the inside seam after each use to maintain the seal's condition. * Always ensure the unit is unplugged and cool before cleaning and storing.
  • J
    Jessica VargasAug 4, 2025
    Why does my Masterbuilt 20070311 take so long to heat up?
    • R
      randylewisAug 4, 2025
      If your Masterbuilt Smoker is taking longer than 60-70 minutes to heat up, there might be a couple of reasons. Ensure the unit is not plugged into an extension cord. Try to position the unit so that an extension cord isn't needed. Also, make sure the door is completely closed and the latch is securely fastened.
  • K
    kennethpetersonAug 8, 2025
    What to do if the power light won’t come on on Masterbuilt Smokers?
    • C
      Cheryl StephensAug 8, 2025
      If the power light on your Masterbuilt Smoker won't turn on, start by checking the wall connection to ensure it's properly plugged in. Next, verify that a house fuse hasn't tripped, and avoid operating other appliances on the same electrical circuit. If these steps don't resolve the issue, further assistance may be needed.
  • S
    Samantha ClarkAug 13, 2025
    Why is there no smoke from my Masterbuilt 20070311?
    • K
      Katherine GreenAug 13, 2025
      If your Masterbuilt Smoker isn't producing smoke, the most likely cause is a lack of wood chips. Add wood chips to the smoker to generate smoke.
  • S
    Samantha FarmerAug 17, 2025
    What to do if grease is leaking from my Masterbuilt Smokers?
    • A
      Amanda HuntAug 17, 2025
      If grease leaks from your Masterbuilt Smoker through the door and legs, it could be due to several reasons. First, ensure the drip pan is correctly positioned, aligning its hole with the drain hole at the bottom. Excess grease buildup can also cause leaks, so clean the unit thoroughly. Lastly, check the drain tube at the back of the unit to ensure it's not blocked and is draining properly.
  • J
    Jennifer ThomasAug 21, 2025
    How to fix interior light that does not come on in Masterbuilt 20070311 Smokers?
    • S
      Steven HouseAug 21, 2025
      If the interior light of your Masterbuilt Smoker isn't working, first check if the bulb is burned out and replace it with a 15W-25W bulb made for ovens. Also, ensure that the light switch is in the 'on' position.
  • B
    bowmanmelissaAug 26, 2025
    Why will remote not control Masterbuilt 20070311?
    • B
      Brett WilliamsAug 26, 2025
      If the remote isn't controlling your Masterbuilt Smoker, ensure the batteries aren't weak or installed incorrectly. Refer to page 13 instructions for how to install the batteries.

Summary

Smoker Side Shelf Installation

Step 1: Remove Hinge Cover and Screws

Remove hinge cover screw and cover, then detach closest door hinge screws from the hinge.

Step 2: Loosen and Remove Handle Screws

Loosen handle screws and remove those closest to you to allow the rear handle to move freely.

Step 3: Insert Hinge Cover Screw and Nut

Thread hinge cover screw through cover and attach nut, leaving a slight gap for adjustment.

Step 4: Align Shelf Bracket and Secure

Align shelf support bracket with smoker body holes, replace handle and hinge screws, and tighten.

Smoker Side Shelf Positioning

Upright Position

Lift the shelf to its full upright position, push gently towards the smoker, and the hinge will lock.

Downward Position

Lift shelf slightly to unlock, pull towards you, and swing into the downward position.

Masterbuilt 20070311 Specifications

General IconGeneral
BrandMasterbuilt
Model Number20070311
Product TypeElectric Smoker
Fuel TypeElectric
Temperature Range100°F to 275°F
Number of Racks4
Power SourceElectric
MaterialSteel
Digital Control PanelYes
Removable Drip PanYes
Wood Chip TrayYes
Cooking Area730 square inches
Dimensions19.5 x 20.5 x 33.5 inches

Related product manuals