To Next PageTo Next PageWhy is my Masterbuilt Smoker taking so long to heat up?
If your Masterbuilt smoker is taking an excessive amount of time to heat up (longer than 60-70 minutes), first ensure that the unit is not plugged into an extension cord. Set up the unit so that an extension cord is not needed. Also, make sure the door is closed properly and the latch is securely fastened.
What to do if there is no smoke in my Masterbuilt Smoker?
If there is no smoke in your Masterbuilt smoker, the most likely cause is that there are no wood chips. Add wood chips to the smoker.
What to do if grease is leaking out of my Masterbuilt Smoker?
If grease is leaking from your Masterbuilt smoker through the door and legs, there are several possible causes. First, ensure the drip pan is correctly positioned so the hole lines up with the drain hole at the bottom of the unit. Second, the unit may have excess grease or oil build-up, requiring a thorough cleaning. Finally, check the drain tube to ensure it is draining properly.
General| Product Type | Electric Smoker |
|---|---|
| Model Number | 20070213 |
| Brand | Masterbuilt |
| Temperature Range | 100°F to 275°F |
| Power Source | Electric |
| Capacity | 4 Racks |
| Digital Control Panel | Yes |
| Removable Drip Pan | Yes |
| Wood Chip Loader | Yes |
| Fuel Type | Electric |
| Cooking Area | 730 sq inches |
| Warranty | 1 Year |
List of Masterbuilt Electric Smoker models compatible with the stand.
Guidance for using the smoker stand with Generation 2 smokers.
Important safety alerts regarding product usage and handling.
Information on chemicals known to cause cancer or reproductive harm.
Attaching the bottom shelf to the smoker stand legs.
Securing the smoker stand legs to the tabletop.
Important safety note during smoker stand installation.
Attaching the smoker stand to the smoker base using M10 nuts and screws.
Securing the smoker stand to the main smoker body.
Using M10 nuts as spacers to level the smoker.
Returning the assembled unit upright and tightening all hardware.
Safety warnings for assembling the smoker stand.
