START-UP
1. Open charcoal hopper.
2. Place fire starter in fire starter slot under the charcoal grate. Replace the
charcoal grate and light the firestarter.
• Use a food safe fire starter block or twisted paper towel/paper.
• Use caution and wear protective gloves.
• Light with match stick or lighter.
• Wait 30 seconds to 1 minute after lighting fire starter to ensure fire starter is fully lit.
Note – For a faster startup, we recommend using 2 of our fire starters.
3. Pour charcoal on top of lit fire starter.
• Never use fast light charcoal or lighting fluid.
• Wait approximately 1 minute to allow charcoal to start smoking.
• Turn to desired setting and let charcoal burn for 4 minutes.
• Close the hopper lid.
4. Close grill lid.
BATTERY / CORD
Requires four (4) AA batteries (not included).
BATTERY LOCATION
(4) AA BATTERIES
RELOAD
If it is necessary to refill the hopper while cooking, follow the safe reloading instructions below.
Adding charcoal:
1. Turn control knob to off before opening hopper lid.
2. Open hopper lid. Use caution, wear protective gloves, and use cooking utensil to lift hopper door. Hopper lid will be hot!
3. Pour charcoal into hopper.
4. Close hopper lid and reset the control knob to the desired setting.
SHUTDOWN
1. Turn controller off.
2. Open hopper lid and complete burning of remaining charcoal before moving to next step.
3. Close hopper lid and close grill lid.
4. Close top vent.
12
REMOVE SILICONE
PLUG TO ACCESS
CORD POWER SUPPLY
Batteries Y Y N
Corded Y N Y
Powered by Cord Batteries Cord
Remark Removing the cord
switches the grill to
battery power.
Adding the cord
switches the grill to
cord power.
Removing the cord
powers the grill off.
Note: Fire starter will
be placed here.
Operating Instructions
Grill can run exclusively on battery power. In ideal conditions, grill batteries typically last 16hrs.
To Next Page
Loading...
Need help?
General
