Masterclock NTP100 -SERIES - Device Properties and Network Settings; Viewing Device Properties; Configuring Network Settings

NTP100 – Rev 2.2.0 Oct-12
13
© Masterclock
®
, Inc.
NOTE: The Update Firmware option is reserved for future use and appears grayed out.
Clicking a menu choice opens a new window for that function. When working in the management windows, use the
Apply and OK button to accept changes that you have made. Use the Cancel button to exit the screen without applying
changes. NOTE: Cancel does not undo changes that have been saved using the Apply button.
Properties
The properties of the NTP100 device of interest can be viewed in summary form, using this selection. Under “Properties” the
device name, model, and network configuration settings are available.
Network Settings
The network settings must be established for the NTP100 to be accessible to the network. You must be a network
administrator or have their support to complete these functions. Your network administrator determines the information for
the Network Settings.
[Note: The default factory setting for network configuration is to use DHCP/BOOTP.]
[Note: If a DHCP server cannot be found on the network by the NTD clock, the IP address will be
assigned a fallback IP address of 169.254.xxx.xxx]