Masterclock NTP100 -SERIES - Device and IP Configuration; Setting Device Name; Configuring IP Address Settings

To Next Page

To Previous Page

NTP100 – Rev 2.2.0 Oct-12

, Inc.

Set/Reset Password

To set, change or remove the password, enter ‘3’ for this option. Bear in mind that a lost/forgotten password cannot be

recovered.

[Note: the factory default password is: public]

Set Display Intensity

To adjust the clock display intensity (brightness), select option ‘4’. Intensity is controlled with a scale of 1 to 14 with 14

being brightest. Enter the value for the desired intensity setting.