Masterclock NTP100 -SERIES - Device Settings

NTP100 – Rev 2.2.0 Oct-12
15
© Masterclock
®
, Inc.
Device Settings
Adjust configurable parameters affecting NTP100 operation using the available Basic and Advanced Device Settings.
The Device Settings Configuration interface allows for setting the Broadcast/Multicast Parameters including selecting the
mode the NTP100 will serve NTP, setting the multicast address, setting the broadcast frequency and port, as well as for ,
assigning stratum levels, brightness control, and access to advanced settings.
Broadcast/Multicast Parameters
– Allows for setting the NTP mode and parameters of the NTP100 server.
Server port
- The default, well known port for NTP service is 123. This can be changed as desired. Note that some
NTP/SNTP clients will expect NTP servers to operate on port 123 and cannot be configured to utilize alternate ports.