Masterclock NTP100 -SERIES - Specifications Overview; Communication Interfaces and Protocols; Time Code Input & Power Requirements; Battery Specifications

NTP100 – Rev 2.2.0 Oct-12
47
© Masterclock
®
, Inc.
Specifications
Communications – Protocol
• DHCP (enabled by default) configuration, or via Static IP mode entry.
o Network configuration: IP address, Netmask,
o Gateway (Router - DHCP Option 03),
o Primary and Secondary DNS (Domain Name Server - DHCP option 06)
• IPV4
• SNTP /NTP version 4 – UDP, port 123 (default)
o Unicast [Query] (default), and broadcast, multicast
• Telnet – TCP, port 23 (default)
• Control/WinDiscovery protocol – UDP, port 6163
• RS-232 (ASCII) - 9600 baud, 8 data bits, one stop bit, no parity (Models NTP100-GPS and NTP100-OSC only)
Communications – I/O
Ethernet (10mbps) .............................................................. RJ45, 10baseT
Length of communication cable (Cat5/5e) ...................... 100 meters maximum
RS-232 (Programming/Configuration Port) ...................... DB9 male, ((Models NTP100-GPS and NTP100-OSC only)
Length of communication cable ...................................... 3 meters maximum (use standard straight thru cable)
Time Code Input – (model –TC)
Time Code Input Connector ............................................... BNC-female, balanced,
Time Code Input Impedance .............................................. >100kOhm
Supported Time Code Formats ........................................... (Auto- Detection, Auto-Gain Adjust)
SMPTE/EBU/Film ,
(30/25/24 fps), NDF non-drop frame
LTC Linear/Longitudinal, Forward running
User bits with date encoding to Leitch/Masterclock
IRIG-B(0) pulse width coded DC (unmodulated), IEEE 1344
IRIG-B(1) 1 kHz Amplitude Modulated , IEEE 1344
Power Requirements
DC Input Voltage................................................................ 9–28 VDC
DC Input Connector ............................................................ Male Switchcraft locking (p/n L722A)
Optional Threaded Female DC Input Power plug ........... Switchcraft p/n S761K (available by special order)
Power Consumption ........................................................... @12V - 150 mA (1.8W)
Battery ................................................................................ ( see table below).
MODEL Battery Replacement
NTP100-GPS
NTP100-GPS-HS
NTP100-OSC
NTP100-OSC-HS
3V, 255mAh Lithium
Coin Cell
Panasonic BR2330
3V,255 mAh,
23mm, with vertical (solder) tabs ,
or equivalent
NTP100-TC
3V, 17 mAh,
Maintenance Free
Rechargeable
Manganese Lithium
3V,17 mAh, Coin Cell
Maintenance Free Rechargeable
Manganese Lithium
Panasonic ML1220/V1A