Masterclock NTP100 -SERIES - Interface and Identifier Configuration; Configuring Telnet Interface; Setting Reference Identifier

To Next Page

To Previous Page

NTP100 – Rev 2.2.0 Oct-12

, Inc.

Configure Telnet Interface

To adjust this configuration, select option ‘C’. If Telnet is allowed, define the telnet port. The well-known port for telnet

services is 23.

Note: If telnet is disabled, the telnet session will be ended and the user must use WinDiscovery, RS-232 access, or the

Reset Configuration button to re-enable it.

Set Reference Identifier

To adjust this configuration, select option ‘D’. Up to 4 characters may be used to identify the unit.