NTP100 – Rev 2.2.0 Oct-12
5
© Masterclock
®
, Inc.
Model NTP100-GPS (& NTP100-GPS-HS)
1. Locate the antenna in a suitable area so that the top of the antenna module has a clear view of the sky. Do not move it
until after the NTP100-GPS has achieved satellite lock (explained below). Route the antenna cable to the location of the
NTP100-GPS
2. Connect the antenna cable coaxial connector to the gold SMA connector on the rear of the unit (labeled Antenna).
Continue at step 4
Model NTP100-TC
3. Connect the time code signal cable to BNC female connector on the rear of the unit (labeled Time Code Input), and then
to a valid UTC referenced time code signal source.
[Note: The NTP100-TC auto-detects and decodes the date encoded incoming time code signal as UTC referenced time and
treats the incoming time code signal as UTC referenced. Non-date encoded SMPTE or IRIG-B/B(1)
Continue at step 4
NTP100-GPS Rear View
NTP100-TC Rear View
To Next Page
Loading...