INSTALLING ACCESSORIES
All accessories are installed on the multi-
crafter in a similar manner. For the
purposes of describing the accessory
installation, the semicircular blade is used.
DANGER: Always remove the plug
from the power source before installing
or removing accessories or sandpaper.
Failing to remove the plug from the
power source may result in the tool
accidentally being started and causing
serious injury to the operator.
1. Remove the screw (1) and washer (2)
from the accessory holder (3) by
turning the screw counter clockwise.
Use the 5 mm Hex key (4) if the screw
is too tight to be removed by hand
(Fig. 1).
2. Place the blade (5) on the accessory
holder (Fig. 2).
NOTES:
a) Make sure the alignment holes (6) in
the blade or sanding pad fit over the
alignment pins (7) in the accessory
holder and the printed side of the
blade is facing the tool.
b) The blade can be mounted at various
angles left or right of center if
required.
3. Thread the screw (1) through the
washer (2) and the blade and into the
accessory holder threaded hole (8).
4. Turn the screw clockwise until it is
finger tight.
To Next Page
Loading...
Need help?
General
