SCREWDRIVER WORKLIGHT
The cordless screwdriver is equipped with
an LED worklight (1) (Fig. 16). To turn the
worklight ON, press the worklight switch
button (2) once. To turn the worklight OFF,
press the worklight switch again.
NOTE: The worklight will remain ON until it
is manually turned OFF.
For safety reasons, the operator
must read the sections of this
Owner’s Manual entitled “GENERAL
SAFETY WARNINGS”, “POWER
TOOL SAFETY”, “SPECIFIC SAFETY
RULES”, “BATTERY & CHARGER
SAFETY” and “SYMBOLS” before
using this cordless screwdriver.
Verify the following every time the
cordless screwdriver is used:
1. Safety glasses, safety goggles,
or face shield is being worn.
2. The bit holder is correctly
installed and locked into the
collet.
3. The bit is in good condition, and
is fully inserted into the bit
holder.
Failure to observe these safety rules
will significantly increase the risk of
injury.
To Next Page
