SERVICE – cont’d
When servicing a tool, use only identical
replacement parts. Follow the instructions
in the Maintenance section of this Manual.
The use of unauthorized parts or failure to
follow the instructions in the Maintenance
section of this Manual may create a risk of
electric shock or injury.
WARNING: Know your cordless
screwdriver. Do not plug in the charger
until you have read and understand this
Owner’s Manual. Learn the tool’s
applications and limitations, as well as
the specific potential hazards related to
this tool. Following this rule will reduce the
risk of electric shock, fire, or serious injury.
Always wear eye protection. Any power
tool can throw foreign objects
into your eyes and cause
permanent eye damage.
ALWAYS wear safety goggles (not
glasses) that comply with ANSI safety
standard Z87.1. Everyday glasses have
only impact resistant lenses. They ARE
NOT safety glasses.
WARNING: Glasses or goggles
not in compliance with ANSI Z87.1
could cause serious injury when they
break.
Always check to make sure the area where
screws are being driven or where holes
are being drilled does not have any hidden
wiring. Contact with a “live” wire will make
exposed metal parts of the tool “live” and
could result in an electric shock to the
operator.
Do not drive screws or break into existing
walls or other blind areas where electrical
wiring may exist. If this situation is
unavoidable, remove all fuses or
disconnect all breakers feeding the work
area.
Secure the workpiece in a vice or with
clamps. Never hold it in your hand or
across your legs. The rotating action of the
screwdriver may cause the bit to come
loose from the screw and cause injury.
Never carry the cordless screwdriver with
your finger on the switch. The tool is
always in an “ON” condition when the
battery is charged.
Never hold the body of the cordless
screwdriver near the switch while changing
bits. Accidentally touching the switch may
start the tool and possibly cause an injury.
Always use the correct shape of
screwdriver bit that matches the head of
the screw.
Always use the largest size screwdriver bit
that will properly fit into the head of the
screw.
To Next Page
Loading...
