GROUNDING INSTRUCTIONS
IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding
provides the path of least resistance for electric current to reduce the risk of
electric shock. This tool is equipped with an electric cord that has an
equipment grounding conductor and a grounding plug. The plug MUST be
plugged into a matching outlet that is properly installed and grounded in
accordance with ALL local codes and ordinances.
DO NOT MODIFY THE PLUG PROVIDED. If it will not fit in the outlet, have
the proper outlet installed by a qualified electrician.
IMPROPER CONNECTION of the equipment grounding conductor can result
in risk of electric shock. The conductor with the green insulation (with or
without yellow stripes) is the equipment grounding conductor. If repair or
replacement of the electric cord or plug is necessary, DO NOT connect the
equipment grounding conductor to a live terminal.
CHECK with a qualified electrician or
service person if you do not completely
understand the grounding instructions, or if
you are not sure if the tool is properly
grounded.
USE ONLY 3-WIRE EXTENSION CORDS
that have 3-prong plugs and 3-prong
outlets that accept the tool's plug as shown
in Fig. A. Repair or replace damaged or
worn cord immediately.
CAUTION: In all cases, make certain the outlet in question is properly
grounded. If in doubt, have a certified electrician check the outlet.
To keep the appliance plug and outlet dry,
use a "drip loop" in the cord connecting the
saw to the outlet (Fig. B). The drip loop is
that part of the cord that is below the level
of the outlet or before the connector if an
extension cord is used. To create a drip
loop, allow the power cord to have a
SAVE THESE SAFETY INSTRUCTIONS
⁄
WARNING: THIS WET TILE SAW IS FOR INDOOR USE ONLY. DO
NOT EXPOSE TO RAIN OR USE IN DAMP LOCATIONS.
IV. Electrical information
6
To Next Page