2016 OWNERS MANUAL / 0249
The original bridge connector in the ballast system must be rein-
stalled if the optional plug-in bags are removed from the system.
Failure to do so will result in any water in the ballast system
evacuating into the storage compartment, potentially flooding
the compartments and could potentially sink the boat, resulting in
serious injury or death.
In the systems that operate on timers, note that the timer operation
varies by model. Timers may also be impacted by the addition
of optional bags. See your authorized MasterCraft dealer for
assistance in determining the proper setting for timers.
Special Attention
Be aware that the engine must be operated at 1500 RPM during the
fill and empty processes. Check engine specifications for related
engine idle speed, which, in some instances, may be too low for
the empty/fill operation to be properly accomplished. Failure to
increase engine RPM to the required level may result in malfunction
or permanent damage to the ballast pumps that force the water
through the system. Such damage is not covered under your
warranty.
Special Attention
NEVER tow a trailer with water in the boat’s ballast tank(s)!
Even small amounts of water can cause serious problems with the
required balance of the boat on the trailer. (See the Trailer section
of this Owner’s Manual if you own a MasterCraft trailer. Note that
this information is also applicable when towing with trailers built
and sold by other manufacturers. Correct balance is critical to safe
trailering.)
Water MUST be pumped out of ballast tanks prior to towing the
boat on any trailer. Even small amounts of water can adversely
affect the balance of the boat on the trailer and tow connection,
which can cause the tow vehicle driver to lose control of the rig.
Failure to follow instructions can result in significant damage to
the tow vehicle, trailer and/or boat, other vehicles on the road, and
serious injury or death, including, but not limited to, bystanders.
Additional Special Attention
The ballast pump impeller MUST be replaced on a regular basis (at
least annually, but more often may be necessary). Its purpose is
to move water from the intake into the ballast tank, and vice versa
when emptying the ballast tank. Through usage, the impeller, by de-
sign, will wear. (See Care and Maintenance section of this Owner’s
Manual.) Authorized MasterCraft dealers can provide guidance to
locate any and all pumps. Failure to follow directions may result in
damage to the ballast pump that is not covered under warranty.
To Next Page
Loading...
Need help?
General
