stowed. Even soft objects can cause injury when underway. Under
normal operations, there will be some vibration, and this may loosen
hardware over time.
• Check that all required Scheduled Maintenance Checks and
Services (see following sections) were performed.
After Operation
• Check for fluid leaks.
In boats equipped with a ballast system, drain water from the ballast
system before placing the boat on the trailer. If the boat has ballast-
pumping assistance to remove water from the ballast system,
note that the engine must be running at least 1500 RPM during the
pumping process (for both fill and empty operations). This will ne-
cessitate draining water prior to ceasing operation of the boat and
loading on the trailer. More information regarding ballast systems
appears in various sections of this Owner’s Manual, but pay particu-
lar attention to the information under Boat Operations.
• Check the fins (where equipped), propeller, rudder and shaft for
damage after removing the boat from the water.
To Next Page
Loading...
Need help?
General
