Mastervolt MASS SINE 12/500

EN / MASS Sine 12/500 / March 2000
25
2.1 WARNINGS AND SYMBOLS
Safety instructions & warnings are marked in this
manual by the following symbols:
CAREFUL !
special data, restrictions and rules with
regard to preventing damage
a WARNING refers to possible injury to
the user or significant material damage
to the charger if the user does not (care-
fully) follow the procedures.
2.2 USE FOR INTENDED PURPOSE
1 The inverter is constructed as per the applicable
safety-technical guidelines.
2 Use the inverter only:
• in a technical correct condition;
• in a closed, wel-ventilated room, protected
against rain, moisture, dust and non conden-
sing circumstances;
• observing the instructions in the user's and in-
stallations manual.
Never use the inverter in situations
where there is danger of gas- or dust
explosion!
3 Use other than as mentioned above is not consi-
dered to be consistent with the intended purpo-
se. Mastervolt is not liable for any damage resul-
ting from failure to comply with the above.
2.3 ORGANIZATIONAL MEASURES
The user must always:
• have access to the user's manual;
• be familiar with the contents of this manual.
This applies in particular to chapter 2, Safety
Guidelines and Measures.
2.4 MAINTENANCE & REPAIR
1 If the inverter is switched off during maintenance
and/or repair activities, it should be secured against
unexpected and unintentional switching on:
• switch off the connection with the batteries or
remove the inverter fuse;
• be sure that third parties cannot reverse the
measures taken.
2 If required, use only original spare parts. The in-
verter has no serviceable parts, except the fan
and pcb.
2.5 WARNING FOR SPECIFIC DANGERS
1 Connect the earth of the inverter output to the
central ground and use a RCCB switch in the in-
verter output.
2 Protect the DC wiring with a fuse, according to
the guidelines in this users manual.
3 Check the wiring at least once a year. Defects
such as loose connections, heat damaged cables
etc. must be corrected immediately.
SAFETY GUIDELINES AND MEASURES
2 SAFETY QUIDELINES AND MEASURES