Mastervolt MASTERLINK MICC User Manual

6 November 2004 / Masterlink MICC / EN
2 SAFETY GUIDELINES &
MEASURES
2.1 Warnings and symbols
Safety instructions and warnings are marked in
this manual by the following symbols and
pictograms:
a procedure, circumstance, etc which
deserves extra attention.
CAREFUL
Special data, restrictions and rules with
regard to the prevention of damage.
WARNING
a WARNING refers to possible injury to
the user or significant material damage
to the MICC if the user does not
(carefully) follow the procedures.
2.2 Use for intended purpose
1 The Masterlink MICC is constructed as per
the applicable low voltage directive.
2 Use the Masterlink MICC only:
x in a technically correct condition;
x in a closed room, protected against rain,
moisture, dust and non condensing
circumstances;
x observing the instructions in the manual
WARNING Never use the Masterlink
MICC at locations where there is danger
of gas or dust explosion!
3 Use other than as mentioned under 2 is not
considered to be consistent with the
intended purpose. MASTERVOLT is not
liable for any damage resulting from the
above.
2.3 Organisational measures
The user must always:
x Have access to the user manual
x Be familiar with the contents of this manual.
This applies particularly to Chapter 2, Safety
Guidelines & Measures.
2.4 Warning for special dangers
1 Check the wiring at least once a year.
Defects such as loose connections, burnt
wiring etc. must be corrected immediately.
2 Do not work on the Masterlink MICC or the
system if it is still connected to a power
source. Only allow changes in your electrical
system to be carried out by qualified
electricians.
3 Installation must be done in accordance with
local standards.
4 The battery voltage can be dangerous. Use
caution and pay careful attention when
installing the Masterlink MICC. Avoid short
circuiting. Voltages above 34 V can be
dangerous.

Mastervolt MASTERLINK MICC Specifications

General

Brand	Mastervolt
Model	MASTERLINK MICC
Category	Controller
Language	English