How to fix Mastervolt MASTERLINK MICC Controller when there is no display function?
If your Mastervolt Controller's display isn't working, the issue might be with the wiring. Check the wiring for any errors, especially the power supply connections at pin 1 and 2.
What to do if my Mastervolt MASTERLINK MICC Controller shows no amp reading?
If your Mastervolt Controller isn't displaying an amp reading, it's likely a wiring problem. Check the wiring, paying close attention to the connections between the shunt and pins 3 and 4.
Why is my Mastervolt MASTERLINK MICC showing no volt reading?
If your Mastervolt Controller shows no volt reading, there may be an error in the wiring. Check the wiring, especially the voltage sense connections at pins 1, 2, 5, and 6.
How to troubleshoot inaccurate amp readings on a Mastervolt Controller?
If the amp readings on your Mastervolt Controller are inaccurate, it could be due to distortion on the shunt wiring. Replace the existing wiring with a twisted pair cable between the shunt and pins 3 and 4. Also, rerun the wires, keeping them away from equipment that might cause noise.
What to do if Time remaining function indicating '------' during discharge on Mastervolt MASTERLINK MICC?
If the 'time remaining' function on your Mastervolt Controller displays '------' during discharge, the shunt wiring might be reversed. Check the installation drawing and correct the wiring, paying close attention to the distinction between the battery side and the system side.
Why is my Mastervolt MASTERLINK MICC not showing the voltage reading of the secondary battery?
If your Mastervolt Controller isn't displaying the voltage of the secondary battery, the secondary battery may not be connected, or it may be wrongly connected. Check the wiring to pins 7 and 8. Connect a wire between the minus of the main battery and the minus of the secondary battery.
Why does the backlight of my Mastervolt MASTERLINK MICC switch off after 15 seconds?
The backlight on your Mastervolt Controller might be switching off after 15 seconds because the unit is in sleep mode. Press one of the buttons to exit the sleep mode.
Guide for safe operation, installation, maintenance, and correction of minor malfunctions.
Safety instructions and warnings marked with symbols and pictograms like 'i', 'CAREFUL', 'WARNING'.
Use the MICC as intended, in a protected environment, follow guidelines, and be aware of special dangers like wiring and voltage.
Lists necessary tools such as saws, drills, spanners, and materials like shunts, cables, and connectors for installation.
Detailed steps for installing the Masterlink MICC, including cut-outs, shunt placement, and wiring connections.
Instructions on connecting cables between batteries, charger, and inverter before connecting the Masterlink MICC.
Process to synchronize the meter with installed batteries after charging them for at least 24 hours.
Steps to set the battery capacity for accurate readings, noting it must be done when batteries are 100% charged.
How to switch the battery charger on/off via the "Charger" button and the meaning of related LEDs.
How to switch the inverter on/off using the "Inverter" button and the status of the Inverter-LED.
Setting the low voltage threshold and low Ah discharge floor for the alarm, with system voltage detection.
Table listing common problems, their possible causes, and recommended actions for resolution.
List of error codes displayed by the Masterlink MICC, with descriptions and recommended actions.
General| Output Voltage | 12/24 V DC |
|---|---|
| Display | LCD |
| DC System Voltage | 12/24 V |
| Protection class | IP21 |
| Input voltage range | 8 - 35 V DC |
| AC Inputs | 1 |
| Alarm Outputs | 2 |
| Communication | MasterBus |
| Weight | 0.3 kg |
| Humidity | Max 95% non-condensing |
| Input Voltage | 12/24 V DC |
To Next Page
