Mastervolt Soladin 700 Web User Manual

6 COMMISSIONING SET UP VIA WI-FI
6.1 COUNTRY CODE SETTING
At first commissioning you have to set the country code. Only
with the country code set, the Soladin starts inverting. To
configure the Soladin inverter, you will need a Wi-Fi display
device like a notebook, tablet or Wi-Fi phone. Follow next
steps.
As the Soladin switches off in dark, settings
can be performed during daylight only.
As the country has not been selected yet, the Soladin will send
out a wireless network as accesspoint automatically. After 30
minutes, this network will be switched off automatically.
Figure 6-1: Soladin as Access point mode
Figure 6-2: Soladin internal page country setting
6.2.1
6.2.2
6.2.3
Figure 6-3: Setting up the internet connection
Figure 6-4: Internet mode
After completion of the setup, the Soladin Web
will start inverting power.
6.2 REGISTER TO INTELLIWEB
For registration to IntelliWeb, visit
http://intelliweb.mastervolt.com.
6.2.1 Standard connection to Wi-Fi network
Connect to the internet router by selecting the network SSID
and entering the network key. The term “SSID“ refers to the
name used to indentify the specic internet router. “Network
key“ refers to the pass word or pass phrase required to
prevent unauthorized access to communication. Follow the
instructions on your Wi-Fi display.
Press “Save and connect“ to complete the setup and connect
the inverter to the internet. The Soladin Web
- disconnects from Access Point Mode,
- connects to the internet router, see figure 6-4,
- redirects you to IntelliWeb automatically.
Press “Save“ if advanced settings have to be applied before
finishing the setup.
1 Check if the Wi-Fi led is blinking 1 time to indicate
it is sending its network. Otherwise push the
WLAN button till the Wi-Fi LED blinks slowly.
5 Select if you wish to setup your inverter for
internet (recommended).
2 Using your notebook, tablet or phone, connect to a
wireless network called: mastervolt-soladin-XXXX
XXXX resembles the last four digits of the
serial number.
3 When connected, open your webbrowser and type
in the address bar http://10.0.0.1 The Soladin
internal page will show up, see figure 6-2.
4 Select the country of installation using your Wi-Fi
display connected to the Soladin, see figure 6-2.
After first commissioning, this feature is locked.
12
|
EN / Soladin 700/1000/1500 Web User’s Manual

Mastervolt Soladin 700 Web Specifications

General

Brand	Mastervolt
Model	Soladin 700 Web
Category	Inverter
Language	English