Mastervolt Soladin 700 Web User Manual

6.2.2 WPS connection to Wi-Fi network
Make sure your internet router supports WPS before selecting this option.
This way you do not have to ll in the network key. Pressing the WPS button is sufcient.
Figure 6-5: Make sure your internet router supports WPS
6.2.3 Do not connect the Soladin to the internet
Select this option when no internet access is available. Press “close connection“ in the screen to complete the setup. At a later
stage, connection to the internet can be made by restarting the setup procedure.
6.3 DE-COMMISSIONING
If it is necessary to de-commission the Soladin, follow the instructions in order of succession as described below:
1. Cut off the grid voltage by switching off the AC distribution switch in the meter cupboard.
2. Disconnect the Amphenol connectors from the Soladin Web.
3. Disconnect the AC cable from the Soladin. Now the Soladin Web can be demounted in a safe way.
6.4 LED TABLE
The Soladin is equipped with a WLAN (Wi-Fi) button, see Overview position 6. This button enables three Wi-Fi modes
subsequently in this order:
1. Off (no Wi-Fi network)
2. Soladin as Access Point mode (SAP mode), for connection between the inverter and the Wi-Fi display
3. Internet mode (for connection with IntelliWeb using the internet router).
These modes can be checked by means of the Wi-Fi LED indication (second column).
LED Indication of the LED Meaning Wi-Fi mode
(toggle button)
Status LED On Grid fault
blinking 6 times ●●●●●● ●●●●●● Hardware error
blinking 5 times ●●●●● ●●●●● Solar voltage too high
blinking 4 times ●●●● ●●●● Temperature too high
blinking 3 times ●●● ●●● No country selected
blinking 2 times ●● ●● Isolation fault
blinking 1 time ● ● Solar voltage low
Power LED Slow Blinking Starting
Fading (slow=low < > < >
power, fast=high) <> <> Normal operation
Wi-Fi LED On Connected with IntelliWeb Internet mode (IM)
blinking 4 times ●●●● ●●●● Connecting with IntelliWeb Internet mode (IM)
blinking 3 times ●●● ●●● Getting IP address from wireless router Internet mode (IM)
blinking 2 times ●● ●● Connecting to router for IntelliWeb Internet mode (IM)
blinking 1 time ● ● Inverter setup Access point (SAP)
Off Wireless network disabled Off
Status + Power Fast blinking ● ● Software update in progress
Status + Power
+ Wi-Fi Off Insufficient irradiation
Table 6-1: Wi-Fi button and LED indications
6.5 MANUAL REGISTRATION FOR INTELLIWEB
If you wish to register for IntelliWeb at a later moment, you need to start the Soladin network manually. Follow the steps in
section 6.1 to configure the Soladin for your Wi-Fi display and register to IntelliWeb.
EN / Soladin 700/1000/1500 Web User’s Manual
|
13

Mastervolt Soladin 700 Web Specifications

General

Brand	Mastervolt
Model	Soladin 700 Web
Category	Inverter
Language	English