Match PP 62DSP - Technical Specifications; Warranty and Disclaimer Information

27
Output power RMS / max:
• Front / Rear channels @ 4 Ohms: .............................4 x 35 / 70 Watts
• Front / Rear channels @ 2 Ohms: .............................4 x 50 / 100 Watts
• Subwoofer output @ 2 Ohms: ....................................1 x 160 / 320 Watts (4 channels each 40/80 Watts)
Frequency range .............................................................20 Hz - 22,000 Hz
Number of input channels................................................4 x highlevel, 1 x MEC
DSP resolution .................................................................56 Bit
DSP processing power ....................................................172 MHz
Total harmonic distortion (THD) .......................................< 0.01%
Signal-to-noise ratio.........................................................> 103 dB
Damping factor ................................................................> 100
Input impedance ..............................................................13 Ohms
Input sensitivity ................................................................5 - 11 Volts
Max. remote output current .............................................500 mA
Undervoltage detection....................................................10.5 Volts (max. 5 sec. down to 6 Volts)
Dimensions (H x W x D) ..................................................44 x 184 x 139 mm / 1.73 x 7.24 x 5.47“
Additional features ........................................................... Variable input sensitivity, fully stabilized internal
power supply with start-/stop capability, 56 Bit
digital signal processing, internal memory for
2 different sound setups, USB input, MATCH
Extension Card slot, input for optional remote
control, stereo line outputs with balanced output
transformers (oating ground).
The limited warranty comply with legal regulations.
Failures or damages caused by overload or im-
proper use are not covered by the warranty. Please
return the defective product only with a valid proof
of purchase and a detailed malfunction description.
Technical specications are subject to change! Er-
rors are reserved! For damages on the vehicle and
the device, caused by handling errors of the mod-
ule, we can’t assume liability. These devices are
certied for the use in vehicles within the European
Community (EC).
Technical Data
Warranty Disclaimer
Note:
“The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by
Audiotec Fischer GmbH is under license. Other trademarks and trade names are those of their respective owners.”