Dear Customer,
Congratulations on your purchase
of
this high-qua-
lity MATCH product.
With the PP 82DSP, MATCH is setting new stan-
dards
in
the evolving plug & play market.
General installation instructions for MATCH
components
To
prevent damage to the unit and possible injury,
read this manual carefully and follow all installati-
on instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
damage to the unit, fire and/or risk of injury.
For
a proper performance and to ensure full warranty
coverage, we strongly recommend to get this pro-
duct installed by an authorized MATCH dealer.
Install your PP 82DSP in a dry location with suf-
ficient air circulation for proper cooling
of
the
equipment. The amplifier should be secured to
a solid mounting surface using proper mounting
hardware. Before mounting, carefully examine the
area around and behind the proposed installati-
on location to insure that there are no electrical
cables or components, hydraulic brake lines or any
part
of
the fuel tank located behind the mounting
surface. Failure to do so may result
in
unpredictable
damage to these components and possible costly
repairs to the vehicle.
We wish you many hours
of
enjoyment with your
new MATCH PP 82DSP.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the
PP
82DSP amplifier
The PP 82DSP may only be installed
in
vehicles
which have a negative ground electrical system.
Any other system may cause damage to the
amplifier and the electrical system
of
the vehicle.
Use only the provided MATCH cable for con-
nection of the
PP
82DSP. The use of other
cables can result
in
damage of the ampli-
fier, the head unit
I radio or the connected
loudspeakers!
Prior to installation, plan the wire routing to
avoid any possible damage to the wire harness.
All cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
The fuse may only
be
replaced
by
an
identically rated fuse
(2
x 25 A) to avoid damage
of the amplifier.
13
To Next Page
Loading...
