Matco Tools MAXTPMS 2.0 - Keyfob Test

MATCO TOOLS MAXTPMS 2.0 - User Guide
UM-MDMAX-MA2-01 User manual MATCO TOOLS MAXTPMS 2.0 Page 23/47
4. KEYFOB TEST
This section is to test the strength of the keyfob RF signal.
Click the Keyfob icon to
start keyfob test.
Hold keyfob in front of the
tool, then press keyfob
buttons to test the signal.
➢ Green bars show a keyfob working within its range to the device.
➢ Red bars show a low signal strength, indicates low battery.
Press Test button to start
a new test.