Matco Tools MD95 - Recording (Capturing) Live Data

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
24
 If Live Data is not supported by the vehicle under test, an
advisory message displays. Press SYSTEM MENU
to return
to the System Menu.
 If custom Live Data was previously configured, the Select PIDs
to Use screen displays.
- To use the existing custom Live Data selections, select Use
existing PIDs, then press ENTER
. Proceed to step 5.
- To configure new custom Live Data, select Select new PIDs,
then press ENTER . The Custom Live Data menu displays.
Proceed to step 3.
 If custom Live Data was not
previously selected, the Custom
Live Data menu displays. Proceed
to step 3.
3. Press UP
and DOWN to scroll
through the available PIDs. When the
PID you wish to display is highlighted,
press ENTER
(a "checkmark"
shows to confirm your selection). Repeat until only the PIDs you
want to display are selected.
 To deselect a PID, highlight the PID, then press ENTER .
The checkmark is removed.
4. When you are finished making your selection(s), press LD to
continue.
 If no PIDs have been selected, an advisory message displays.
Press ENTER
to return to the Custom Live Data menu.
5. The Scan Tool is now in "Custom Live Data" mode. Only the PIDs
you selected are shown.
 To change the current custom Live
Data selections, select Reselect
PIDs, then press ENTER
to
return to the Custom Live Data
menu. Repeat step 3.
6. To exit the "Custom Live Data" mode,
press LD to return to the Live Data
Menu.
RECORDING (CAPTURING) LIVE DATA
You can record and save several frames of Live Data information for
each PID supported by the vehicle in the Scan Tool's memory.
There are two ways the Scan Tool can "record" Live Data:
 Record by DTC Trigger