- 7 -
2.2 DIMENSIONS AND WEIGHT
Dimensions
410 x 210 x 270 mm Weight 3,5 kg
2.2 POWER SUPPLY
Li-Ion 1800mA/h 3.7V Batteries. Rechargeable from USB port (5Vdc) via supplied cable.
3. GENERAL SAFETY STANDARDS
3.1 GENERAL STANDARDS
To ensure the safety of machine operators:
Any tampering with the appliance not pre-
emptively authorised by the manufacturer
exempts the manufacturer from any
responsibility for damage caused by or to it.
The removal or tampering with safety devices
entails a violation of the safety standards.
Machine use is only allowed in areas where
there is no risk of explosions or fires.
Only the original fittings can be used. The use
of unoriginal fittings exonerates the
manufacturer from all responsibility.
Check the appliance is in ideal working
conditions and that its parts are not worn or
faulty before Carry out all necessary
maintenance
Do not wear loose clothing, ties, chains, or
anything else which could become caught in
the frame or other moving parts of the
appliance.
Be aware of the danger of electrical shocks
from direct or indirect contact due to
unforeseen electrical faults.
Do not subject the appliance to violent impact.
Do not expose the appliance to fire, welding
sparks or extreme temperatures.
Do not bring the appliance into contact with
corrosive substances.
Do not wash the appliance with jets of water.
Check the workspace around the machine is clear
from potentially dangerous objects.
The machine operator must wear appropriate
work clothing such as protective glasses, gloves
and mask in order to avoid damage from, for
example, harmful dust projection. Wear a lower
back support when lifting heavy parts. There
should be no hanging objects such as bracelets or
otherwise, long hair should be protected with
relevant precautions, shoes must be appropriate
for the type of operation to be carried out.
DURING USE
When operating check there are no conditions
of danger. Immediately stop the machine when
it is functioning irregularly. Contact the
authorized Sales Service department.
For the operator’s safety do not touch any part
of the appliance when testing and use the
appropriate individual protection devices in
order to keep the operator safe.
RISK OR DANGER PROTECTION DEVICES
FINGER
SQUEEZE CUTS
OR ABRASIONS
REINFORCED
GLOVES
MATERIAL FALL
ACCIDENT-
PREVENTION
SHOES
4. INSTALLATION INSTRUCTIONS
4.1 LOCATION
The equipment must be placed in an ideal position and environment for the use it has been conceived for
(laboratory use and protected from atmospheric agents) and that the machine is placed by a qualified operator.
ALLOWED TEMPERATURE
From +5°C to +40°C
ALLOWED RELATIVE
HUMIDITY
from 30% to 70%
GENERAL ADVICE:
The machine must be installed in an area which allows ease of access to all parts so that maintenance may
be carried out.
Unauthorized people and objects which could be potential sources of danger must not be permitted in the
area surrounding the machine. Do not position the equipment near instruments or appliances which could
produce vibrations.
To Next Page
Loading...