- 12 -
7. MAINTENANCE
DANGER
All the operations of maintenance, checking and control must be carried out by
personnel professionally qualified and knowledgeable about machine and
mechanisms. All the operations must be carried out when the machine is switched
off and with the feeding cable physically separated from a knife switch of feeding.
It is permitted to use only the original spare parts. The use of not original spare
parts free the constructor from the responsibility.
7.1 EXTRAORDINARY MAINTENANCE
For extraordinary maintenance operations refer directly to the Manufacturer.
DANGER
The removal of the safety devices or any tampering of the machine could cause
risks to the operator or to any other people.
7.2 AUTHORIZED MAINTENANCE CENTRES
For information on the nearest authorized help center it is essential to contact the Manufacturer.
8. SPARE PARTS
WARNING
DANGER
Only original spare parts can be used.
Use of unoriginal spare parts exempts the manufacturer from all
responsibility. Procedures for substitution of spare parts will be provided by
the manufacturer along with the part. For spare parts contact the
manufacturer’s Sales Service department.
RE142-99 1 16 KN LOAD CELL WITH CONNECTOR
FOR E142 MODEL
STVS03651 1 DIGITAL DISPLAY
RE142-96
1 SPARE HYDRAULIC PUMP
WARNING
Please note the replacement of some parts might imply a necessary
recalibration of the instrument.
9. INACTIVITY
Ensure all machine parts are in safe working order before operating it again should the machine be inactive
for a long period of time. When in doubt contact the Manufacturer.
10. DECOMMISSIONING THE MACHINE
Should it be decided that the machine is to be no longer used, proceed as follows:
Disconnect the electrical supply network by removing the connecting cable therefore making it unusable.
Make the potential sources of danger harmless, such as sharp or protruding parts.
Dismantle the machine; divide it into similar parts and dispose of according to the standards in force
Recycling notice for the disposal of electrical and electronical devices
This symbol, shown on the device or on the package and/or the documentation, suggests that the
device should not be disposed together with other home garbage at the end of its life cycle.
To avoid further environment, or health-care damage, caused by the unsuitable disposal of
garbage, the user should separate this device from other different types of garbage and recycle it
in responsibly to avoid the reuse of material resources. Users must take care at the disposal of
the equipment by taking it to the nearest recycling site for appropriate recycling treatment for electrical and
electronical devices. Gathering and Recycling deplete devices allow the preservation of natural resources and
grant them the adequate treatment by respecting health and environment. For further information on your local
recycling site please contact your local council or city waste treatment department.
To Previous Page
Loading...