23
Revision Descriptions
Wiring diagram and expanations changed to reflect 4 LED interface as opposed to
the 2 LED interface.
Corrected Numbering for Option 24.
Adding setting 3 and 4 to Option 2 to correctly display annunciator dots with a
Toledo data stream.
Option 1 changed to display the software version, previously located
under option 20.††Option 19 for test mode was removed and options 19 and
20 were added to perform the same way as option 18 to allow a total of 3
blank out characters.
Updated Enclosure dimension chart. Modified Options 13, 14, 15, and 23.
Added Options 25-27. Expanded Stoplight options to allow for values 3-5.
Added new Section for replacement parts.
Siemens Sub Menu added under Option 28 to interface with a Modbus protocol
on a BW500. Option may also be entered by holding RIGHT and LEARN
buttons during countdown. Added Wireless manual. Revised dimension chart to
add SBL-9 displays
Expanded Stoplight Options to allow for one time ASCII commands.
Correction on Section 7: Stoplight Instructions: momentary green uses pin 13
and momentary red uses pin 14.
Rebuilt Manual, lots of minor changes. Added Option 29
Fixed Minor Typos
05/07
10/07
6/08
10/10
11/12
07/13
08/13
04/19
10/19
To Previous Page
Loading...