PROTON 206/308 V1 System Manual 85
Walk-In Class of Service
What’s this?
• A station user can use his toll control from any station.
• This feature is very useful for managers when they move away from their seat. Normally they have highest-
level toll control. Now when they go on the shop-floor (where the Toll Control is normally of low level) and if
they wish to use their Toll Control, this feature comes to their help. Using this feature, they can make calls as
per their Toll Control from any station. This facility is password protected hence its misuse can be avoided.
How to use it?
Example:
Station user 23 who is allowed 95 calls is at station 25 who is denied 95 calls. Station user 23 wants to make 95
calls from station 25. To accomplish this station user 23 should use Walk in Class of Service from station 25.
Important Points:
• Only one call is allowed at a time using this feature. i.e. to make two calls one after the other, you will have to
dial the code to make first call and then again to make second call.
• Walk-In Class of Service is allowed to all the station.
• Walk-In Class of Service is not allowed with default dynamic lock password.
1 Lift handset. Dial tone
2Dial 111-Station-User Passowrd. Confirmation tone
3 Disconnect and lisft the handset again. Dial tone
4Dial '0' or '5' or '61' or '62' or '63'. Trunk dial tone
To Next Page
Loading...
