11
4.8 AUTO CALIBRATION INSTRUCTIONS
AUTO CALIBRATION PROCEDURE
After initial installation or replacement of the incline motor, auto calibration should be run.
1) Press and hold both LEVEL keys for 3-5 seconds. Manager Mode should appear on the display.
2) Press the LEVEL UP or DOWN key until the display reads Service Mode. Press ENTER.
3) Press the LEVEL UP or DOWN key until the display reads Auto Calibration. Press ENTER.
4) This will run the Auto Calibration. If the calibration passes, it will say complete. Press and hold the STOP key to return to the normal start
screen.
5) If the calibration does not pass, contact Matrix Customer Technical Support at 866-693-4863 ext 3.
CHAPTER 4: CONSOLE OVERLAY AND WORKOUT DESCRIPTION
To Next Page
Loading...
