Matrix A5X-04 - GENERATOR BELT REPLACEMENT

37
9.5 GENERATOR BELT REPLACEMENT
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks from the machine as outlined in Section 9.1.
3) Remove the front shrouds as outlined in Section 9.2.
4) Remove the generator as outlined in Section 9.4.
5)Toinstallanewbelt,rstputthebeltinstallationtoolonthepulley(FigureA).
6) Put the new belt on the installation tool (Figure B).
7) Turn the pulley until the belt is installed. Rotate the pulley at least 3 full rotations to insure that the belt is centered.
8) Reverse Steps 1-4 to re-assemble the unit.
9) Test the Ascent Trainer for function as outlined in Section 9.22. .
FIGURE A
FIGURE B
CHAPTER 9: PART REPLACEMENT GUIDE