77
10.5 TV BRACKET INSTALLATION
CHAPTER 10: BIKE SPECIFICATIONS AND ASSEMBLY GUIDE
FIGURE JFIGURE I
FIGURE H
FIGURE GFIGURE F
7) Remove the 4 screws and the small Matrix logo from the front of the console mast (Figures F & G).
8) Install the rubber pad from the TV bracket kit over the hole in the console mast (Figure H).
9) Connect the coax cable to the one coming up the console mast and push the TV power wire into the console mast so that it is accessible
Figure I).
10) Connect the TV bracket to the console mast using the 4 screws that were removed in Step 7 (Figure J).
To Next Page
Loading...
