62
9.10 DRIVE SET REPLACEMENT - CONTINUED
9) While a tech is pushing the drive set towards the front of the unit (the drive set will still be supported by the guide screw - Figure G), the other
tech should remove the chain from the sprocket simultaneously (Figure H).
10) Remove the drive set from the unit (Figure I). note: The drive axle will need to be rotated so that the pulleys are horizontal to t through
the side covers (Figure J).
11) Reverse Steps 1-10 to install a new drive set. note: Torque the bolts removed in Step 7 to 40N-m.
12) Test the Climb Mill for function as outlined in Section 9.20.
FIGURE HFIGURE G
CHAPTER 9: PARTS REPLACEMENT GUIDE
FIGURE I FIGURE J
To Next Page
Loading...
