Panel200 in Server Mode
If you want the Panel200 to work in Server Mode then select Server
Mode as the Panel mode option. Save the configuration and restart
the Panel.
Ÿ Then re-login into the Panel200
Ÿ Click Configuration> Panel Configuration. Click Server
Settings.
Ÿ Select the Network interface through which you want to
connect with the server.
Ÿ Enter the IP address or host name of the PC where COSEC
server is installed.
Ÿ Test the connection by specifying the URL of the server.
Ÿ The connected Panel200 will show status as Online.
Adding Panel200 in COSEC Server
To use the Panel200 with COSEC server application, you must
add the Panel200 in COSEC Server using following steps.
Ÿ Open the COSEC Server application on a browser.
Ÿ Click Devices > Device List > Click the New icon.
Ÿ In the Select Device Type To Be Added window, select
Panel200.
Ÿ Click the Continue button. The Device Configuration window
will open.
COSEC Centra
Server
TCP/IP
RS-485 or
TCP/IP
ARC Controller
(or any supported Door)
Panel200
Figure 6
15
16
To Next Page
Loading...
