41
1) Remove the plastic cover where the dual action handlebar meets the pedal arm (Figure A).
2) Remove the bolt and bushings where the dual action handlebar and the pedal arm meet (Figure B).
3) Remove the two bolts holding the dual action handlebar to the console mast pivot (Figure C).
4) Remove the pivot cap and handlebar (Figure D).
5) Reverse steps 1-4 to install a new dual action handlebar.
6) Test the Elliptical Trainer for function as outlined in Section 8.21.
FIGURE A FIGURE B
FIGURE C FIGURE D
8.14 DUAL ACTION HANDLEBAR REPLACEMENT
CHAPTER 8: PART REPLACEMENT GUIDE
To Next Page
Loading...
