Matrix ETERNITY NE Quick Start 10
• You must purchase the VMS License to activate it. See “Activating License Key” under Configuring
ETERNITY NENX for instructions.
Connecting to Trunks
CO Trunks (Analog two-wire Trunks)
• Use standard, good quality, twisted-wire pair telephone cables with RJ11 plugs to connect the CO Ports of
ETERNITY NENX to the Trunk Lines from your CO (central office).
Mobile Networks
Enabling SIM PIN Protection
• Protect the SIM Card from unauthorized use with a Personal Identification Number (PIN) on the SIM (in
consultation with the customer/owner of the SIM).
To enable SIM PIN protection,
• get a mobile handset. Insert the SIM Card into the mobile handset.
• from the mobile handset, enable PIN Protection.
• change the SIM PIN to 1234 (this is the default PIN for both SIM Cards used in the system). You can
change this SIM PIN later from the Jeeves when configuring the Mobile Port.
• remove the SIM Card from the mobile handset.
If you do not want to use PIN protection, insert the SIM in the mobile handset and disable PIN protection.
Remove the SIM Card from the mobile handset and insert it in the Mobile Port of ETERNITY NENX.
Inserting SIM Card in the Mobile Port
• To insert the SIM Card in ETERNITY NENX,
• insert the SIM into the SIM slot, with its contact side facing up.
• push the SIM backwards into the slot. The SIM is locked inside the slot.
• to unlock the SIM within the slot, push the protruded portion of the SIM backwards again.
• repeat the same steps to insert the other SIM Card.
• Connect the Antenna to the antenna connector.
• Switch On power supply, if you have finished connecting all the required ports.
• At every power on of the system, it takes about 3 minutes for the Mobile Ports to get registered with the
network. Once registration with the mobile network is completed, the Mobile Port can be used.
To Next Page
Loading...
Need help?
General
