Matrix MW401 User Manual

11
6. Check the number of marks on the strip to see the level of water
hardness.
If the hardness of the water you use is above 63 dE or if you are using well
water; you are recommended to contact your local water board to confirm
the water hardness level and to use filter and water refinement devices.
Please note: The level of water hardness is preset to level 3.
1. Press and hold down the programme selection button
2. Press the Power button to switch on the dishwasher
3. Keep the programme selection button pressed until all programme
indicator lights and the end of programme indicator light flash.
4. To adjust the level, press the programme selection button until the
required level is shown on the display: The programme lights will
illuminate as in the table below.
5. To store the selected water hardness level, press the power button.
Water hardness level British hardness dE Indicator lights illuminated
1 0-6 P1
2 7-14 P2
3 15-21 P3
4 22-28 P4
5 29-39 P1 and P4
6 40-63 P2 and P4

Matrix MW401 Specifications

General

Door color	Not applicable
Built-in display	Yes
Appliance placement	Fully built-in
Control panel color	Stainless steel
Cycle time	160 min
Noise level	52 dB
Delayed start timer	-
Dishwashing programs	Eco, Intensive, Pre-wash
Number of place settings	12 place settings
Number of washing programs	4
Washing class	A
Annual water consumption	3360 L
Annual energy consumption	273 kWh
Current	13 A
Power consumption (off)	0.05 W
Water consumption per cycle	12 L
Energy consumption per cycle	0.95 kWh

Weight and Dimensions

Width	- mm